| Accident
Reconstruction Network > News >
June 2005 >06/08/05
Accident Reconstruction
News Article
Autoliv Shows New Rollover Protection System
STOCKHOLM, Sweden, June 8, 2005 (PRIMEZONE) -- At the
Enhanced Safety of Vehicles (ESV) international conference held in Washington,
D.C., Autoliv Inc. -- the worldwide leader in automotive safety -- showed
a new seat belt and an airbag system for rollover protection. According
to the tests, the system could eliminate virtually all serious head and
neck injuries in rollover crashes, as long as the roof of the vehicle can
withstand the ground impact without extensive intrusion.
Currently, about 10,000 people are killed annually in rollover
crashes in the United States alone. In the future, many lives will be saved
thanks to electronic stability control (ESC) systems and side curtain airbags
that are being introduced on an increasing number of vehicles. In vehicles
equipped with rollover sensors, the seat belt pretensioners could also be
activated to tighten the seat belt, thereby increasing the distance between
the occupant's head and the roof of the vehicle. However, the curtain airbag
is designed to protect only on one side of the occupant, the so-called near-side.
When an occupant moves toward the other side of the vehicle (the far-side)
during the rollover crash, the upper body could slip out of the shoulder
belt, creating a greater risk of injury to himself and others. As a result,
40% of the fatalities in rollovers involve far-side occupants.
Autoliv, the inventor of the curtain airbag for near-side
protection, has now tested a system that addresses this problem. ``We started
by simply turning a regular seat belt around and attaching the shoulder
portion of the seat belt to the upper inner corner of the seat back rest
instead of to the door pillar,'' explained Associate Professor Ola Bostrom,
who presented a paper with the test results at the ESV conference. ``Inboard
belts have been tested before. However there is a risk of injury from this
type of belt to the occupant's neck and throat, at least to far-side occupants
in side impacts. We think we have now solved that problem,'' said Bostrom.
Autoliv has put a small airbag at the inboard side of the
back rest side (i.e., on the right side of the driver seat on a left-hand
driven vehicle). This Side-Support Airbag (SSA) prevents the occupant from
severe loads to the neck and the throat should the occupant slide towards
the shoulder portion of an inboard belt. To reduce slack the seat belt is
also tightened up to 15 centimeters (6 inches) using a pyrotechnic seat
belt pretensioner. ``Our system is simple, but the tests results are very
promising,'' declared Professor Bostrom. In every test conducted by Autoliv
the new system succeeded in preventing the head from reaching the roof of
the vehicle, while the head of the test dummies using a traditional seat
belt system hit the roof with great violence.
New Specially-Designed Rollover Test Rig In order to ensure
valid comparability testing, Autoliv has developed a special sled test rig.
With it, the company's researchers can simulate a typical rollover when
the vehicle rotates half a turn and then lands on the roof. Only the body
of a car or an SUV is needed for the tests, which makes testing less expensive
than traditional full-car testing. The test rig simulates all three phases
in a typical rollover: 1) tripping, 2) air born and 3) ground impact. In
this way it has become possible to simulate the complex motions of a human
body in a typical rollover without using real vehicles.
New Specially-Designed Test Dummy
It has also been necessary to make changes to the test dummies,
because their spines are stiff and rigid. In humans, however, the spine
is curved and therefore the distance between the head and the hip often
increases a little when the occupant is turned upside down in a rollover.
Consequently, the spines of the test dummies has been modified to provide
the correct elongation characteristics.
Inquiries:
Associate Professor Ola Bostrom, Autoliv Research
Mob. +46-733-61 43 42
Mats Odman, VP Corp. Comm
Phone +46-8-587 20 623 or mob. +46-708-32 09 33
For high-resolution images please contact pernilla.eklund@autoliv.com.
Autoliv Inc. develops and manufactures automotive safety systems
for all major automotive manufacturers in the world. Together with its joint
ventures Autoliv has 80 facilities with 40,0000 employees in 30 vehicle-producing
countries. In addition, the company has development and engineering centers
in six countries around the world, including 20 test tracks, more than any
other automotive safety supplier. Sales in 2004 amounted to US$6.1 billion.
The Company's shares are listed on the New York Stock Exchange (NYSE:ALV
- News) and its Swedish Depository Receipts on the OM Stockholm Stock Exchange
(SSE:ALIV).
This information was brought to you by Waymaker.
http://www.waymaker.net
The following files are available for download:
http://wpy.waymaker.net/client/waymaker1/WOLReleaseFile.aspx?id=105920&fn=wkr0007.pdf
http://wpy.waymaker.net/client/waymaker1/ImageArchive/Image.aspx?image_id=4402
###
Back to Accident
Reconstruction News |